본문 바로가기 대메뉴 바로가기

TRIEL® SB5802A

TPEE

문의하기

TYPICAL DATA OF TRIEL® SB5802A GRADE

PROPERTY UNIT ASTM METHOD TYPICAL DATA
Physical
Specific Gravity - D792 0.95
Melt Flow Rate (230℃, 5kg) g/10min D1238 17
MECHANICAL
Tensile Strength at yield kgf/㎠ D638 160
Tensile Elongation at break % D638 914
Flexural Strength at yield kgf/㎠ D790 35
THERMAL
ELECTRICAL
OTHERS
※The figures listed in this table are typical values obtained under the standard test methods and may not be applicable for products that are under different application condition.

PROCESSING GUIDE FOR TRIEL® SB5802A GRADE

General processing conditions for TRIEL® SB5802A are shown below.
Drying prior to processing is essential to ensure desired appearance and property performance.

SPECIFICATION UNIT CONDITIONS
Drying Temperature 100~110
Drying Time hr 3~4
Moisture Content, Max % 0.02
Melt Temperature 200~230
Nozzle Temperature 230~250
Front Temperature 230~250
Middle Temperature 230~250
Rear Temperature 200~230
Mold Temperature 30~50
Back Pressure MPa 0.0~0.1
Screw Speed rpm 10~50
Vent Depth mm 0.02~0.08